Thread -bucking rubber joint

The threaded wire buckle rubber joint consists of the internal and external rubber, curtain layer and steel wire ring, and then loosen with metal flange or parallel connector. It is the flexible part of the pipeline connection. Due to its superior material performance and advanced production technology, it is widely used in buildings in buildings. , Give water drainage, fire, pipeline, chemical industry, electricity and other fields.

The main product of the product is mainly selected as raw materials. The high elasticity, high air, weather resistance, and radiation resistance of rubber are used to absorb the horizontal, axial, and corner displacement caused by the vibration of the pipeline, reduce the vibration and noise of the pipeline, and the compensation temperature changes. Thermal expansion and cold shrinkage are not limited by uneven pipelines and uncomfortable flanges.

1. When installation and use, first let the rubber joints be in a natural state, tighten the connection flange and pipes at both ends of the rubber joint to match the flange, remember not to artificially deformed the product; The bolts of the orchid surface should be repeatedly tightened to prevent pressure deviation and prevent local leakage.

2. Pipelines that install rubber joints must have a fixed bracket or fixed bracket, and the force of the fixed bracket must be greater than axial force. In the process of vertical installation and overhead installation, the corresponding fixed brackets and stress brackets should be installed at both ends of the product to prevent falling off after work pressure. For high -rise water supply or suspended water supply, the pipeline should be fixed on the suspension, brackets or anchor frames, and the joints shall not bear the weight and axial force of the pipeline itself. Essence

3. When installing the above -mentioned products, please use the butterfly valve flange or small diameter flange to avoid the phenomenon of flange, leakage, and water seepage after installation.

4. Stay away from the heat source during installation.